Messages

1

Support / Re: Whack a Mole Tut Help/Basic Questions

« on: October 04, 2013, 10:08:24 pm »

I was able to resolve this issue after trying two new projects and importing the 2dtoolkit two more times. Third time is the charm so to speak. I never could figure out what caused it but trying again two more times did the trick. I suspect my computer hates me.

2

Support / Re: Whack a Mole Tut Help/Basic Questions

« on: September 26, 2013, 01:29:36 am »

I've loaded up the project provided and I noticed several differences. Only one of their images are diced. Also, under settings even though I've set the max size to 2048 the atlas width and atlas height still show as different. Any idea what might be different? Would you mind running through the tutorial, as written, from a clean set up to see if you hit the issue?

Edit: This message has been edited for politeness.

3

Support / Re: Beginner Tilemap Question

« on: December 06, 2012, 01:09:41 am »

Unikron,

   I recreated the project and imported only the 2dtoolkit and 2dtoolkit ui along with the first person controller, re-followed the steps and it seems to have worked fine. It even works on my other project today. I'm going to blame it on incompetence of myself. My advice to anyone that stumbles upon this thread, start over again and see if round 2 goes better.

4

Support / Re: 2D Toolkit 2.0 Backwards Compatibilty

« on: December 05, 2012, 01:20:06 am »

If you could give a few months heads up I think it'd be fine for what it's worth. Sometimes dead weigh has to be excised in the name of progress.

5

Support / Re: Beginner Tilemap Question

« on: December 05, 2012, 01:15:34 am »

It doesn't appear to have any physical size in scene view. I select "TileMap" from the Hierarchy panel and hit Command F to find it. No rectangle of boundaries appear. I have the position at 0,0,0 which is where the tk2dCamera is at. I tried adjusting the scale on the tile map to see if that did anything but it doesn't appear to. I've attached a screen shot in case that helps. I'm sure this is something I'm doing that's silly so I especially appreciate any help while I get on my feet so to speak.

6

Support / Beginner Tilemap Question

« on: December 05, 2012, 12:42:14 am »

http://www.unikronsoftware.com/2dtoolkit/doc/tilemap/tutorial.html

The tutorial ends by basically saying left click on a tile and then left click in the scene view. If you do that in unity 4 left clicking in scene view without clicking on anything just deselects everything and doesn't paint any tiles. I'm sure I'm missing a minor step in between. If anyone could enlighten me or even just link me to something I missed it'd be much appreciated. I tried searching the forum for about twenty minutes but I couldn't find the right keywords to bring up this exact issue.